2400/5000V SP non-shielded power cable

SUBMERSIBLE PUMP
NON-SHIELDED POWER CABLE
2400/5000 VOLT -TYPE MV-105
3 CONDUCTORS WITH GROUND

Conductors: Consist of uncoated soft, copper strands meeting the requirements of ASTM B3. Conductor shall be supplied as Class B compact per ASTM B496. Conductor Shield: The Conductor Shield consists of an extruded semi-conducting layer. Insulation: The insulation is ethylene-propylene rubber (EPR) extruded in a single pass with the conductor and insulation shields to the wall thickness. Conductor Coding: Phase identification for multi-conductor cables is provided by a colored stripe on the insulation shield of each of the conductors (red, black, blue). Ground: Standard multi-conductor cables include one bare copper ground in one of the outer cable interstices. The ground wire is sized per UL requirements. Custom ground wire sizes and configurations are available upon request. Assembly: Conductors and ground wire are cabled together the required number of insulated non-shielded conductors and the ground wires (if applicable) with a left hand lay and suitable fillers are used in the interstices to round out the cable cross section. A mylar binder tape is applied overall. Jacket: A sunlight and ozone resistant jacket of polyvinyl chloride (PVC) or chlorinated polyethylene (CPE) is extruded over the single and multi-conductor assembly.

Multi-conductor Non-Shielded, power cables for the 2400V level with an overall jacket and rated for wet and dry locations. Suitable for use as a submersible cable. These cables are rated for used as submersible cables or can be installed in duct or conduit and in properly supported aerial installations.

Download File 'P7376N-SP.pdf'